You may experience many types of errors from time to time if you are a printer user. These errors stop the conventional proceedings of your computer and are extremely tedious. These are typically time-consuming and result in a delay in our work. Hp printer error code 0xb9000009165. These kinds of errors are known as alphanumeric errors as they contain both letters and numbers. The x is used to represent either a letter or a number.
Why printer that is hp code 0xb9000009165 caused?
The 0x9000009165 error occurs because of ink system failure when our system our bodies just isn’t|ink that is getting the cartridges because of which it is really not having the ability to perform properly.
How does the ink system failure occur?
This error might occur because of any among the reasons that are the following :
- The nozzle regarding the printhead of your printer might have grown to be jammed.
- There was an issue associated with the driver of your printer.
- The cartridges have grown to be empty or are low of ink.
- Cartridges have grown to be dirty.
- The cartridges that people are utilizing to print our documents are not suitable for our printer.
How to solve Hp printer error code 0xb9000009165?
We could try solving Hp printer error code 0xb9000009165 by making use of the techniques that have been which were mentioned below:
METHOD 1:
- Check if the nozzle is now jammed. In that case then clean in. The steps are the following:
- There are two main ways to clean the printhead of your printer. The first way is to wash the printhead through the control panel of your printer.
- Load a paper that is unused the input tray of one’s printer.
- Press the power button and keep on holding it.
- Press the Cancel button twice and also the Resume button once.
- Release the power button.
The next way is always to clean the printhead utilizing the with the hp solution center. The steps are:
- Go right to the Start button present from the Taskbar.
- Click on All Programs
- Click on Hp.
- Go right to the Hp Solution Center.
- Go to Settings
- Click the printer Toolbox. The Printer Toolbox Window will show up.
- Go directly to the Device Service Tab.
- Click on Clean Printhead.
- Click on Clean.
- Wait for the process to complete and then attempt to print a full page to see whether our printer is functioning properly.
METHOD 2:
The second method is to wash the cartridges to ensure that no dust particles have settled in it. The steps to wash the cartridges are the following:
- Turn on the printer.
- Wait for the printer to prevent moving.
- Open the cartridge access door.
- Take out of the cartridges out one at a time carefully by pushing on the tops.
- Rub them gently with a bit of close dipped in distilled
- Ensure that you do not use water that is excess.
- Leave them in the wild to dry. Usually do not leave them way from the printer for very long.
- Place them back inside their slots.
- Close the cartridge access door.
- Attempt to print a typical page to see if the error still persists or otherwise not.
